6
a
Quick start guide
Smoke & Carbon
Monoxide Combination
Detector
DTCTCS10WT
For more information see the extended
manual online: ned.is/dtctcs10wt
Specications
Product Smoke & Carbon
Monoxide Combination
Detector
Article number DTCTCS10WT
Dimensions (l x w x h) 134 x 134 x 40 mm
EU Certication EN 14604:2005+AC:2008
EN 50291-1:2018
Battery type 3V (EVE CR17450). Non-
replaceable, sealed-in
lithium
Battery lifespan Up to 10 years
Sensor lifespan Up to 10 years
Alarm volume >85 dB @ 3 m
Test button Yes
Low-battery alert Yes
Smoke alarm sensitivity 0.096 - 0.146 dB/m
Detectable ppm (CO) 20 – 999 ppm
Operating temperature 0 °C - +40 °C
Operating humidity 30% ~ 93%
Main parts (image A)
1 Indicator
2 Test/Silence button
3 Alarm
4 Mounting bracket
5 Plugs (2x)
6 Screws (2x)
Safety instructions
-
WARNING
• Ensure you have fully read and understood the
instructions in this document before you install or
use the product. Keep the packaging and this
document for future reference.
• Only use the product as described in this document.
• Do not use the product if a part is damaged or
defective. Replace a damaged or defective product
immediately.
• The product has a limited lifetime. Replace the
product 10 years after the date of purchase. Write
the purchase date on the manual for future
reference.
• Do not drop the product and avoid bumping.
• Do not expose the product to water, rain, moisture
or high humidity.
• Test the product once per week to ensure proper
operation.
• Do not paint the product.
• Do not use this product in a dusty or smoky
ambience.
• Do not use the product for outdoor uses, the
product is designed for indoor use.
• Replace the product under conditions of
malfunction, end of life or low-battery.
• This product may only be serviced by a qualied
technician for maintenance to reduce the risk of
electric shock.
• Do not use aerosols (air fresheners, hair spray, paint)
near the product.
• This product may not prevent the chronic eects of
carbon monoxide exposure and will not fully
safeguard individuals at special risk.
• The installation of the product should not be used as
a substitute for proper installation, use and
maintenance of fuel red facilities, including
appropriate ventilation and exhaust systems.