en Microwave
12
Setting the microwave
Example: Microwave output 600 W, cooking time 5
minutes.
1. Touch the # touch button.
The appliance is ready to use. The maximum
microwave output is displayed as the default value in
the display. You can change this at any time.
2. Use the ( or ) touch button to select the required
microwave output.
The microwave output and a default cooking time
are shown in the display.
3. Touch the & touch button.
The cooking time can be set.
4. Use the ( or ) touch button to set the required
cooking time.
5. Touch the # touch button.
The appliance starts the operation. The cooking time
counts down on the display.
Notes
■ When you switch on the appliance, the highest
microwave output always appears in the display as a
suggestion.
■ If you open the appliance door when the appliance
is in use, the fan may continue to run.
Cooking time elapsed
An audible signal sounds.
Operation has finished.
Stopping the audible signal early:
Touch the 0 touch button.
Note: After touching the 0 touch button, the timer
function appears; after a short time, it automatically
disappears. If you touch the 0 touch button again, the
timer function will disappear instantly.
Use the # touch button to switch off the appliance.
Changing the cooking time
This can be done at any time.
Use the ( or ) touch button to change the cooking time.
The operation continues.
Changing the microwave output
This can be done at any time.
Use the % touch button to change the microwave
output.
Use the ( or ) touch button to set the required
microwave output.
The cooking time remains unchanged.
The operation continues.
Note: If the set cooking time exceeds the maximum
time for the microwave output of 900 W, it is reduced
automatically. The operation stops. Use the # touch
button to start the operation.
0LFURZDYH
:
PLQ_V
0LFURZDYH
:
PLQ_V
0LFURZDYH
:
PLQ_V
To Next Page
Loading...
Need help?
General
