Basic operation en
7
7.7 Switching off the fan run-on
▶
Press
.
7.8 Switching on the NoiseReduction
function
1
The noise reduction function reduces the fan noise.
The function is possible in all fan settings, except in fan
setting
.
▶
Press .
a The NoiseReduction function remains active even
after the appliance is switched off.
7.9 Switching on the AirFresh function
The AirFresh function switches on the ventilation sys-
tem for approx.five minutes per hour at fan setting1.
▶
Press
.
a appears on the display.
7.10 Switching on automatic mode
1
The optimum fan setting is set automatically using a
sensor.
▶
Press
.
7.11 Switching off automatic mode
1
▶
Press
.
a The appliance starts at the previously selected fan
setting.
a The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a Automatic mode runs for a maximum of four hours.
7.12 Sensor sensitivity
1
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡ Factory setting:5
¡ Lowest setting:0
¡ Highest setting:9
7.13 Setting the sensor sensitivity
Requirement:The appliance is switched on.
1.
Press and hold
.
a The setting is displayed after approx. onesecond.
2.
Press
or to change the setting.
3.
Release to save the setting.
7.14 Saturation indicator
If the grease filters or odour filters are saturated, cor-
responding symbols flash after the appliance is
switched off.
Note:You can set the saturation indicator in the Home
Connect app depending on the filter used.
Clean the saturated grease filters and, in doing so, ob-
serve the cleaning instructions in these instructions.
Change the saturated odour filters and observe the in-
structions in the accompanying instructions.
If odour filters can be regenerated, follow the instruc-
tions in the accompanying instructions.
7.15 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off,
ap-
pears on the display for the grease filter.
¡ After the appliance has been switched off, ap-
pears on the display for the odour filter.
▶
Press .
a The saturation indicator is reset.
7.16 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement:The appliance is switched on.
1.
Press and hold
.
‒ To set circulating-air mode (non-regenerative fil-
ter), press or until indicator 2 appears on the
display.
‒ To set circulating-air mode (regenerative filter),
press or until indicator 3 appears on the dis-
play.
‒ To set air extraction mode, press or until indic-
ator 1 appears on the display.
2.
Release to save the setting.
7.17 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
▶
Press
.
7.18 Setting the brightness
▶
Press and hold
until the required brightness is
reached.
7.19 Switching on the audible signal
Requirement:The appliance is switched on.
▶
Press and hold
and at the same time for ap-
prox. threeseconds until a signal sounds.
a appears on the display.
7.20 Switching off the signal tone
Requirement:The appliance is switched on.
1
Depending on the appliance specifications
To Next Page
Loading...
Need help?
General
