Basic operation en
7
2.
To switch on intensive mode 1, press again.
a appears on the display.
a After approx. 6 minutes, the appliance automatically
switches to fan setting 3.
6.5 Switching off intensive mode
▶
Press .
6.6 Switching on the fan run-on
1
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶
Press .
a The fan run-on starts at fan setting1.
a The appliance switches off automatically after ap-
prox. 10 minutes.
6.7 Switching off the fan run-on
1
▶
Press .
6.8 Switching on the AirFresh function
The AirFresh function switches on the ventilation sys-
tem for approx.five minutes per hour at fan setting1.
▶
Press .
a appears on the display.
6.9 Switching on the NoiseReduction
function
The noise reduction function reduces the fan noise.
The function is possible in all fan settings, except in fan
setting .
▶
Press .
a The NoiseReduction function remains active even
after the appliance is switched off.
6.10 Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
▶
Press .
6.11 Switching off automatic mode
▶
Press .
a The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a Automatic mode runs for a maximum of four hours.
6.12 Sensor control
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡ Factory setting:5
¡ Lowest setting:0
¡ Highest setting:9
6.13 Setting the sensor control
Requirement:The appliance is switched on.
1.
Press and hold .
a The setting is displayed after approx. onesecond.
2.
Press or to change the setting.
3.
Release to save the setting.
6.14 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Note:Colour temperature settings are available in the
HomeConnect app provided the appliance has this
function.
▶
Press .
6.15 Setting the brightness
▶
Press and hold until the required brightness is
reached.
6.16 Switching on Ambient Light
1
You can switch on the Ambient Light independently of
the ventilation system.
▶
Press .
6.17 Ambient Light
1
- Setting the
brightness
▶
Press and hold until the required brightness is
reached.
6.18 Ambient Light
1
- adjusting the
colour
Requirement:The appliance is switched off.
1.
Press .
2.
Press or repeatedly until the required colour is
set.
6.19 Setting the intermediate position for
the filter cover
On some appliances, the filter cover can be adjusted to
an intermediate position. The intermediate position can
be used to eliminate particularly strong cooking smells
and large amounts of steam.
▶
Take hold of the filter cover in the centre and open it
carefully.
1
Depending on the appliance specifications
To Next Page
Loading...
Need help?
General
