en Troubleshooting
48
Fault Cause and troubleshooting
E:6103 lights up. Wa-
ter is not drained.
Not an appliance fault. Wastewater pump is blocked
or the cover of the wastewater pump is loose.
1. Clean the wastewater pump.
→"Clean wastewater pump", Page52
2. Secure the cover of the wastewater pump so it
clicks into position.
→"Clean wastewater pump", Page52
E:9240 lights up. Filters are soiled or blocked.
▶ Clean the filters.
→"Cleaning filters", Page44
All LEDs lit up or
flashing.
Electronics have detected a fault.
1. Press the main switch button for approx.
4seconds.
The appliance is reset and restarted.
2. If the problem occurs again:
‒ Switch off the appliance.
‒ Pull out the mains plug or switch off the fuse in
the fuse box.
‒ Wait at least 2minutes.
‒ Switch on the fuse in the fuse box or insert the
mains plug.
‒ Switch the appliance on.
3. If the problem occurs again:
‒ Contact customer service.
→"Customer Service", Page53
To Next Page
Loading...
Need help?
General
