NEFF S353ITX00E User Manual

Troubleshooting en
45
Fault Cause Troubleshooting
Appliance does not start. Appliance door is not closed
properly.
▶ Close the appliance door.
Programme starts automat-
ically.
You did not wait until pro-
gramme ended.
▶ →"Terminate programme",
Page30
Appliance stops during the
programme or cuts out.
Appliance door is not closed
properly.
▶ Close the appliance door.
Power and/or water supply
has been interrupted.
1. Check the power supply.
2. Check the water supply.
Top basket is pressing
against inner door and pre-
venting appliance door from
being closed securely.
▶ Check whether the rear panel of the
appliance is being pressed in by a
socket or hose holder that has not
been removed.
▶ Arrange the tableware so that no
parts project beyond the basket
and prevent the appliance door
from closing properly.
All LEDs lit up or flashing. Electronics have detected a
fault.
1. Press the main switch button for ap-
prox. 4seconds.
→"Controls", Page15
The appliance is reset and restar-
ted.
2. If the problem occurs again:
‒ Switch off the appliance.
‒ Pull out the mains plug or
switch off the fuse in the fuse
box.
‒ Wait at least 2minutes.
‒ Switch on the fuse in the fuse
box or insert the mains plug.
‒ Switch the appliance on.
3. If the problem occurs again:
‒ Contact customer service.
→"Customer Service",
Page48
Button on the control panel
is not described and does
not work.
No function is saved for the
button.
▶ Not an appliance fault.

NEFF S353ITX00E Specifications

General

Brand	NEFF
Model	S353ITX00E
Category	Dishwasher
Language	English