To Next PageTo Next PageWhat to do if Nemaxx FL10-VdS Smoke Alarm sounds unwanted alarms?
If your Nemaxx Smoke Alarm is sounding unwanted alarms, you can press the test button to pause the alarm. You may also need to clean the smoke alarm device referring to the “maintenance and cleaning” section. Alternatively, try moving the smoke alarm device to a new location and then press the test button.
What to do if Nemaxx Smoke Alarm device does not sound when tested?
If the Nemaxx Smoke Alarm device does not sound when tested, you must activate the alarm before installation. Also, clean the smoke alarm device referring to the “maintenance and cleaning” section. If failures persist during the warranty period, you can return it to your retailer. If the unit is out of warranty, replace it with a new alarm.
What to do if Nemaxx Smoke Alarm sounds different from it is used to?
If your Nemaxx Smoke Alarm sounds different from how it usually does, clean the smoke alarm device referring to the “maintenance and cleaning” section. If failures persist during the warranty period, you can return it to your retailer. If the unit is out of warranty, replace it with a new alarm.
General| Brand | Nemaxx |
|---|---|
| Model | FL10-VdS |
| Category | Smoke Alarm |
| Language | English |
Test weekly, silence safely, use licensed installers.
Understand device limits, household awareness, and fire detection capabilities.
Test weekly via button press; avoid open flame.
Solutions for common issues like no test sound, low battery chirp, or fault mode.
Steps for during a fire: evacuate calmly, check doors, meet outside, call fire dept.
Steps to activate the unit and attach the mounting bracket.
How to fix the alarm to the bracket and perform the final test.
Ensure secure attachment to prevent injury.
