Nemtek MERLIN 4 - Bypassing Siren and Strobe; Gate Alarm and Chime Settings

Using your key pad
7
BYPASS THE SIREN AND STROBE
LIGHT (SILENT ALARM)
Enter your PIN and press the * key, enter the digit 4, then press the # key.
The beeper in the control panel and energizer will still be active.
UN-BYPASS THE SIREN AND
STROBE LIGHT
Enter your PIN and press the * key, enter the digit 7, then press the # key.
MAKE THE GATE ALARM
IMMEDIATE
Enter your PIN and press the * key, enter the digit 2, followed by the digit 7, then press
the # key. The GATE ALARM light will start flashing, with a cadence of one flash every 5
seconds, to confirm the gate alarm is immediate.
MAKE THE GATE ALARM
DELAYED
Enter your PIN and press the * key, enter the digit 2, followed by the digit 4, then press
the # key. The default gate delay is 4 minutes.
BYPASS THE GATE ALARM
Enter your PIN and press the * key, enter the digit 2, then press the # key.
The GATE ALARM light will start flashing slowly to confirm that the gate alarm is
bypassed. To cancel the bypass, repeat the same sequence of keys.
TURN THE GATE CHIME ON/OFF
Press the * key, enter the digit 2, then press the # key. The control panel will beep twice
to confirm that the gate chime is turned off and three times if it’s turned on. If the chime is
on, the control panel will beep once if the gate closes and three times if it opens.