Need help?Do you have a question about the Nemtek MERLIN STEALTH and is the answer not in the manual?
General| Brand | Nemtek |
|---|---|
| Model | MERLIN STEALTH |
| Category | Power Supply |
| Language | English |
Important safety warnings regarding unit operation and unauthorized modifications.
Steps to enter installer programming mode using the default PIN.
Procedure to safely exit the installer programming mode.
Process for changing the default installer PIN.
Configure the duration the siren remains active after an alarm event.
Define the period to ignore subsequent alarm events after the siren time.
Set the maximum alarm events before the re-arm timer becomes active.
Set the re-arm time for the alarm annunciation process.
Configure the delay before Gate 1 alarm activation.
Configure the delay before Gate 2 alarm activation.
Adjust open circuit fence voltage for M15/M25 and M18/M28 models.
Configure the open circuit low power fence voltage.
Set the fence alarm voltage for High Voltage mode.
Configure strobe light for alarm or fence status indication.
Enable or disable the magnetic switch function.
Information on the unavailable keypad detection feature.
Configure fence voltage mode switching based on Gate 2 input.
Adjust battery monitoring sensitivity and service indication level.
Configure automatic battery checks and acceptable voltage levels.
Set the frequency for automatic battery health checks.
Program a tamper alarm for front lid removal.
Configure remote on/off behavior as absolute or transition sensitive.
Detailed instructions for mounting the unit and replacing its battery.
Diagram illustrating the live wire connection for M15S/M18S.
Diagram for earth wire connection with loop monitoring for M15S/M18S.
Diagram for earth wire connection without loop monitoring for M15S/M18S.
Diagram illustrating the live wire connection for M25S/M28S.
Diagram for earth wire connection with loop monitoring for M25S/M28S.
Diagram for earth wire connection without loop monitoring for M25S/M28S.
Details on fuses F1, F2, F3 and their associated fault symptoms.
Step-by-step guide for safely removing the PC board.
Step-by-step guide for correctly installing the PC board.
Key notes and advice for installers regarding fence setup.
Glossary of terms used in electric fencing and energizer operation.
Safety and regulatory requirements for electric security fences.
Table specifying safe clearances from overhead power lines.
To Next Page
