28
5.00 Off Turns remote control off.
LEVEL
Adjusts the overall output level of the Ventilator II. 12 o’clock is
the default position with the effect signal’s level roughly equal
to the bypass signal.
IV. SWITCH MODES
If the SLOW/FAST switch is pressed and held for 3 seconds on
power up, the Ventilator enters an edit routine enabling the
user to adjust the switch behaviour of the STOP and SLOW /
FAST switch.There are 6 modes (see below) that can be
stepped through by pressing the Stop (decrement) or
Slow/Fast switch (increment): The Lo and Hi Leds indicate the
current setting:
Lo LED blinking 1x/sec, Hi LED off >>> Mode1
Lo LED blinking 2x/sec, Hi LED off >>> Mode2
Lo LED blinking 3x/sec, Hi LED off >>> Mode3
Hi LED blinking 1x/sec, Lo LED off >>> Mode4
Hi LED blinking 2x/sec, Lo LED off >>> Mode5
Hi LED blinking 3x/sec, Lo LED off >>> Mode6
Pressing Stop and Slow/Fast together for 2 seconds stores the
setting and leaves the edit routine. When SWITCH1 is selected
via the Remote parameter, the Switch Mode setting also
affects the external remote’s switch behaviour.
To Next Page
Loading...