Method of installation
2
• Plug the power cable into the socket on the right side of the device and the adapter
into the car's cigarette lighter socket (receptacle).
• Take the windshield suction cups mount from the kit or replace the suction cups with
a 3M adhesive tape pad.
• Insert the loose end of the mount into mount 1 connector.
• Attach the device to the windshield using suction cups or the 3M adhesive tape pad.
• Fix the radar detector at the base of the windshield in a horizontal plane, since the
police radar waves fall onto this area.
• Start the car engine.
• Press ON/MENU to enter the device menu.
• Press ON/MENU or MODE and scroll through the device menu down to Flip Display.
Change No to Yes by pressing DOWN.
• Take the windshield suction cups mount from the kit or replace the suction cups with
a 3M adhesive tape pad.
• Insert the loose end of the mount into mount 2 connector.
• Attach the device to the windshield using suction cups or the 3M adhesive tape pad.
• Fix the radar detector at the base of the windshield in a horizontal plane, since the
police radar waves fall onto this area.
1. Installation on the windshield
2. Installation on the windshield: upside down installation
To Next Page
Loading...