Need help?Do you have a question about the Neptune-Benson Defender and is the answer not in the manual?
General| Filtration Type | Depth filtration |
|---|---|
| Filtration Media | Silica sand or other approved media |
| Construction | Fiberglass |
| Connection Size | Varies depending on model |
| Flow Rate per Area | Up to 25 GPM/ft² |
Detailed wiring schematic for the RMF programmer (120V).
Wiring connections for the recirculation pump motor starter.
Guidance for a quick start-up of the filter system.
Procedure for loading media using vacuum transfer.
Instructions for initiating the filter's cycle start.
Description of the precoat operational mode.
Description of the filter operational mode.
Procedure for the regeneration mode, also known as bumping.
Instructions for discharging media from the filter.
Instructions for adjusting flow regulating valves.
Critical checks before starting the circulation pump.
Steps for conducting a dry test of the system.
Process and indications for refilling filter media.
Step-by-step illustrated guide for charging media.
Step-by-step illustrated guide for filling the system with water.
Guide for setting the timer's clock and day.
Instructions for programming bump cycles using the timer.
How to switch the timer from manual to automatic mode.
How to switch the timer from automatic to manual mode.
Critical safety warning for blower installation and use.
Safety warning regarding hot surfaces and air streams.
Safety warning about electrical hazards during maintenance.
To Next Page