EnergyBar 832 - User Guide Page 9
ENERGYBAR 832 CIRCUIT BREAKER
The 15 Amp circuit breaker is located inside the EnergyBar 832; a yellow status/reset
button is visible on the rear of the EB832.
The yellow button will normally protrude from the back of the EB832 case by
approximately 1.5-2mm. If the circuit breaker has been tripped, the yellow button will
extend farther out, approximately 3mm. This may be seen in the images below.
Normal
Tripped
To reset a tripped circuit breaker, press the yellow button inward. Before resetting the
breaker, identify and resolve the cause of the overload condition which resulted in the
circuit breaker being tripped.
To Next Page
Loading...