How to troubleshoot no power to Neptune Receiver?
If your Neptune Receiver isn't getting power, first check for loose connections at both the vehicle plug and the MRX920. Look for the LED on the power cable. Ensure the red arrow on the cable matches the red dot on the MRX920. Also, check the power cable's internal fuse. Finally, verify the electrical status of the utility vehicle, checking for a dead battery or a blown fuse.
How to fix unable to export all routes on Neptune Receiver?
If you are unable to export all routes on your Neptune Receiver, ensure that all the routes you want to export are selected in the Unload window by checking the corresponding checkboxes.
How to view all accounts in Missed and Captured Reads windows on Neptune Receiver?
If you are unable to view all accounts in the Missed and Captured Reads windows of your Neptune Receiver, check if the filter in the bottom right corner of the Missed and Captured Reads window has been removed.
Why is my WiFi connection not working on Neptune Receiver?
If you're having WiFi connection issues with your Neptune Receiver, check the MAC address under Connection Settings and compare it to the MAC address on the MRX920's label. Also, verify in Receiver Settings that you are connecting as intended (WiFi vs. USB). The LEDs on the front of the MRX920 will indicate the connection method.
What to do if cannot import route file on Neptune Receiver?
If you are unable to import a route file into your Neptune Receiver, ensure that the file you are trying to import is a '.imp' file. If the file type is correct, the file may be corrupt. Try recreating the file in N_SIGHT.
How to fix no audible tone while meter reading on Neptune Receiver?
If you cannot hear an audible tone while meter reading on your Neptune Receiver, verify that the 'Enable Tone' option is checked in the upper left corner of the Routes window. Also, ensure that the volume on your laptop is turned up and not muted.
Why am I not getting readings on my Neptune Receiver?
If you are not getting readings on your Neptune Receiver, ensure the unit is connected correctly. As long as the Rx LED is changing from on to off, your MRX920 is receiving readings. Also, inspect the RF antenna for any crimps or damage.
What to do if no route data is available on Neptune Receiver?
If the MX900 host software is running but no route data is available on your Neptune Receiver, make sure the USB flash drive is properly inserted into your laptop's USB port. Also, ensure the route files have downloaded correctly from the network. If the issue persists, use the Self-Diagnostics tab to check if the data on the USB flash drive is compatible.
Why is my USB connection not working on my Neptune Receiver?
If your USB connection isn't working with the Neptune Receiver, ensure the USB cable is securely connected to both your laptop and the MRX920. If it's still not working, try a different USB cable to rule out damage. Also, check the Receiver Settings to confirm you're connecting as intended (WiFi vs. USB). The LEDs on the front of the MRX920 will flash to indicate the connection method.
General| Temperature Range | -40°C to +85°C |
|---|---|
| Operating Temperature Range | -40°C to +85°C |
| Type | Data Logger |
| Humidity Range | 0% to 100% RH |
| Power Source | Internal battery |
| Measurement Parameters | Temperature, humidity |
| Sampling Interval | 1 second to 18 hours |
| Material | Stainless steel and titanium |
To Next Page
