Reading Modes
Function Explanation
Normal
Normal Mode connects through Bluetooth to a
host device. Selection between Route (filtered)
and RF Test (unfiltered) is made in the host
device software.
To enter this mode from other modes:
1. Press until the mode LED flashes
.
2. Press and the mode LED turns
.
Unattended
Unattended Operations Mode can operate
using the battery or when connected to
vehicle power.
To use this mode with battery power:
1.
Press until the Mode LED is
.
2.
Press .
To use this mode when connected to vehicle
power:
3.
Press until the Mode LED is
.
4.
Press and release.
5. Press again and hold for five seconds,
and then release. The Mode LED is
.
6. Connect the USB.
Note: The USB charger must be capable of
supplying 1A of current.
USB mass
storage
The SD card appears as an external drive to
the PC. To enter this mode:
1. Connect the USB to the R900BCT and to
the PC.
Note: The USB must be connected before the
unit can enter the USB mass storage mode.
2.
Press until the Mode LED flashes
.
3. Press . The SD card now shows as an
external drive attached to the PC.
Accessing the R900
®
BCT
The R900BCT must first be set to Normal Mode to access the R900BCT Status
screen.
While en route Neptune Key, System, UTILS, AMR Status =
, , ,
From the Synchronize screen
TAB twice, UTILS, BeltClip Status =
, ,
Neptune Customer Support
Call Monday through Friday, 7:00 AM to 5:00 PM Central Time:
(800) 647-4832
FAX your question: (334) 283-7497
E-mail a question: support@neptunetg.com
PRC R900BCT 01.19 Part No. 13326-002
Pocket Reference
for the R900
®
Belt Clip Transceiver (BCT)
(Versión en español disponible en
www.neptunetg.com
For... Press...
ON
Press for two seconds.
OFF
Press for two seconds.
Setting Date / Time The R900® BeltClip Transceiver (R900BCT)
sets time with the handheld when the two are
paired. This time comes from the last
handheld synchronization.
To Next Page
Need help?
General
