Nerf BLASTER SCOOTER 2.0 - Assembly Instructions; Stem Deployment and Securing; Blaster and Hand Grip Installation; Blaster Angle and Clip Loading

ASSEMBLY
NERF BLASTER SCOOTER 2.0 ASSEMBLY
1
2 3
Release deck clamp and push up on deck lever
to lock stem into vertical position. Once locked
into position tighten deck clamp.
Insert blaster and stem into down stem of
scooter. Slide stem clamp down over seam
where two stems meet and tighten into
place using the screw driver provided.
Slide hand grip over shaft and snap into
place using lock button.
Deck
clamp
Down
stem
Folded position
Deck
Lever
Hand
grip
4
5
Use blaster angle release button to adjust blaster
angle to 90º or desired liking for riding or blasting.
For fast riding and storing it is recommended that
blaster be in the closed 0° position.
Insert clip into bottom of blaster. Make
sure to insert in correct direction as
instructed on clip.
6
Complete assembly.
Blaster angle
release button
Stem
clamp
Clip
Nerf_blaster_scooter_2_manual.indd 4Nerf_blaster_scooter_2_manual.indd 4 5/9/22 11:48 AM5/9/22 11:48 AM