Nerf BLASTER SCOOTER 2.0 - Battery Assembly and Information; Installing Batteries; Important Battery Safety

BATTERY ASSEMBLY
2
1.5V
AA / LR6
Not included.
x4
1
Locate blaster battery cover on right
side of blaster with screw closure.
Use supplied screw driver to unscrew
and remove battery cover from
blaster.
Use qty 4 (1.5V AA/LR6) batteries to ll
battery compartment. Make sure to follow
battery insertion direction marked in
compartment. Once batteries are installed
properly screw battery cover back on and
secure to blaster.
IMPORTANT BATTERY INFORMATION
WARNING: 1. TO AVOID BATTERY LEAKAGE A. Always follow the instructions
carefully. Use only batteries specied and be sure to insert them correctly by match-
ing the + and – polarity markings. B. Do not mix old batteries and new batteries or
standard (carbon-zinc) with alkaline batteries. C. Remove exhausted or dead batteries
from the product. D. Remove batteries if product is not to be played with for a long
time. E. Do not short-circuit the supply terminals. F. RECHARGEABLE BATTERIES: Do not
mix these with any other types of batteries. Always remove from the product before
recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER
TYPES OF BATTERIES.
2. Should this product cause, or be aected by, local electrical interference, move
it away from other electrical equipment. Reset (switching o and back on again or
removing and re-inserting batteries) if necessary.
Nerf_blaster_scooter_2_manual.indd 5Nerf_blaster_scooter_2_manual.indd 5 5/9/22 11:48 AM5/9/22 11:48 AM