• Note: To remove blaster once installed – you must remove M6 Bolt form inside battery
compartment first.
Step 1: Press the button and insert the
stem into the base.
Step 2: Remove M6 bolt from blaster, slide
the blaster into cradle, and then tighten
blaster to cradle the M6 bolt completely.
Step 3: Load 6 pcs batteries (C type,
1.5V), close the cover and tighten 4pcs
M3 screws completely.
Step 4: Insert the handlebar grips into
the bare handlebars until both locking
buttons “click” into place.
To Next Page
Loading...
