LOADING AMMO:
[IMAGE OF DART LOAD FROM PDF]
Load DARTS into the QUICK RELOAD CLIPS. • Be sure DARTS are inserted in direction indicated on CLIP. • Insert
1 DART at a time and push down. • EACH Included CLIP can hold up to 6 DARTS. Do not insert more than 6
darts.
Insert CLIP into MAIN BLASTER UNIT (make sure arrow on CLIP points away from TRIGGER).
Press CLIP release buttons and remove CLIPS to store or reload.
[IMAGE POINTING OUT RELAESE BUTTONS]
CLEARING JAMS:
[IMAGE OF ACCESS DOOR OPEN]
Check BARREL area for a jammed DART. Open the JAM CLEARING DOOR and remove any jammed DARTS. •
Close JAM CLEARING DOOR.
NOTE: Blaster will not function unless JAM CLEARING DOOR is fully closed.
STORING YOUR BLASTER
NOTE: Do not store blaster ready to fire. • Be sure to unload DARTS from blaster before putting it away.
Remove batteries if storing Blaster Scooter for an extended period of time
IMPORTANT: BATTERY INFORMATION
[Caution Logo] CAUTION: 1. TO AVOID BATTERY LEAKAGE a. Always follow the instructions carefully. Use only
batteries specified and be sure to insert them correctly by matching the + and – polarity markings. b. Do not
mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries. c. Remove exhausted or
dead batteries from the product. d. Remove batteries if product is not to be played with for a long time. e.
Do not short-circuit the supply terminals. f. RECHARGEABLE BATTERIES: Do not mix these with any other types
of batteries. Always remove from the product before recharging. Recharge batteries under adult supervision.
DO NOT RECHARGE OTHER TYPES OF BATTERIES. 2. Should this product cause, or be affected by, local
electrical interference, move it away from other electrical equipment. Reset (switching off and back on again
or removing and re-inserting batteries) if necessary.
To Next Page
Loading...
