OPERATION
1. Place base on a at, stable surface.
2. Be sure the unit is disconnected from electrical outlet before installing or removing any
components.
3. Place Jar onto Base, aligning tabs, and turn slightly clockwise to lock into place. Unit has
a safety design which will not operate if the Jar is not posioned properly onto the Base.
4. Fill Jar with desired foods. Do not exceed Maximum ll line (Max = 50 oz. / 1500mL).
5. DO NOT USE BLENDER WHILE EMPTY OR WITHOUT JAR AND COVER IN PLACE.
6. Place cover onto Jar and push rmly to secure.
7. Install Measuring Cup and turn to lock. If blending hot foods, remove measuring cup
from cover while blending.
8. Set the control dial to ‘OFF’ and connect the cord to 120V electrical outlet.
9. Turn the knob to ‘ON’ posion. Backlight will turn on, indicang power is ON.
10. For auto sengs, press PULSE, ICE or SMOOTHIE to operate in corresponding mode.
11. To adjust speed, turn control dial between Minimum (lowest speed) and Maximum
(highest speed) to choose desired speed seng.
NOTE: DO NOT OPERATE UNIT CONTINUOUSLY FOR MORE THAN 2 MINUTES.
CARE AND CLEANING INSTRUCTIONS
1. Turn control dial to OFF and unplug cord from power outlet.
2. Clean base with a so, wet cloth and mild cleaning soluon. Wipe dry.
3. To clean the Jar, ll halfway with water and mild cleaning soluon, cover and operate at
low speed for 1 - 2 minutes unl clean.
4. Remove Jar and empty contents, rinse and dry thoroughly. CAUTION - BLADES ARE SHARP,
USE CARE WHEN CLEANING!
5. Never use aggresive cleansers or metal scouring pads to clean components.
To Next Page
Loading...
General