Troubleshooting
The charger does not charge:
• Check whether the indicator LED light is on. If not, make sure if the charger and
the outlet has been connected properly. If yes, try a new electrical outlet.
• If the charger does not charge when indicator LED light is on, check if the charger
and vacuum sealer are seated properly, adjust if needed.
It stops working soon after charged.
• Make sure if the indicator LED lights are on during charging, if not, check if the
vacuum sealer and charger are in good contact.
• If the indicateor LED lights are on during charging, make sure if the charging time
is sufcient. Indicator LED light will turn green when fully charged.
• Please contact NESCO customer support 1-800-288-4545 if it still does not work.
Air is not removed from the bag completely.
• Bags are not sealed, reseal the zipper, and then slip the entire zipper with your
nger.
• Replace the zip bag and make sure the valve is clean.
• The items are blocking the valve, position so valve is open or there is too much
stuff inside bag.
• Extend the vacuuming time and press most of air out before sealing zipper.
The canister will not vacuum:
• Make sure the adaptor was well connected to both the vacuum sealer and the
canister.
• Check if the button of the canister was on the position of “seal”.
• Press the lid downward at the very beginning of vacuuming. This will help to seal
canister and lid.
• Check if there is any damage to lid or canister, if yes, do not use.
• Check the function of the vacuum sealer to be sure iti is pulling a vacuum.
• Check if the outer suction has been deformed, fractured or blocked, if yes, change
it for a new one.
To Next Page
Loading...
Need help?
General