Nespresso CitiZ D111 - Troubleshooting

EN
16 17
www�nespresso�com
No light indicator.
➔ Check the mains, plug, voltage, and fuse. In case of problems, call the Nespresso Club.
No coee, no water.
➔ First use: ll water tank with warm water (max. 55°C) and run through machine according to instructions on
page 9.
➔ Water tank is empty. Fill water tank.
➔ Descale if necessary; see Descaling section.
Coee comes out very slowly.
➔ Flow speed depends on the coee variety.
➔ Descale if necessary; see Descaling section.
Coee is not hot enough.
➔ Preheat cup.
➔ Descale if necessary.
Capsule area is leaking
(water in capsule container).
➔ Position capsule correctly. If leakages occur, call the Nespresso Club.
Irregular blinking.
➔ Send appliance to repair or call the Nespresso Club.
No coee, just water runs out (despite inserted capsule).
➔ In case of problems, call the Nespresso Club.
Both LEDs blink during ready mode.
➔ Proceed to descaling.
TROUBLESHOOTING
5870_UM_CITIZ-D_Z2_MASTER_2012_NESP_CLUB_IL_PROD.indd 17 05.05.12 04:58