Nespresso D300 - Making Espresso

LARGE
Displayed when a large cup is being filled
SMALL
Displayed when a small cups is being filled
WAIT STEAM
You have pressed the steam key. The machine is
warming up
.
STEAM READY
The machine has reached the necessary working
temperature. Now you can extract steam.
STEAM
Displayed when steam is drawn off.
TOO HOT
This message is displayed when you wish to
serve coffee immediately after preparing steam
without the temperature having fallen. To cool
the machine down, proceed as described under
«Steam preparation».
TAP CLOSE
When you draw off warm water to reduce the
steam temperature, this message is displayed
after the machine has automatically interrupted
the process of drawing off water.
ENOUGH COFFEE?
This message appears when the cup filling quan-
tity is being programmed.
CHECK-UP
Service message.
- Make sure that there is enough water in the tank.
- Clean the capsule holder as described under
«Cleaning»
- Press the key or with the capsule holder
inserted but without coffee capsules; When
READY is displayed on the display you can pre-
pare your coffee normally. If the message does
not disappear
- Clean the needle cage as described under
«Cleaning».
Making espresso (10-12)
To obtain optimal coffee quality, preheat the
machine daily with the empty capsule holder
and rinse the system before making the first and
after the last espresso of the day. Do this by
pressing the button (9).
●
Fill the tank with fresh water. To preheat the
capsule, leave it in position on the capsule
cage (but empty, i.e. without a capsule ) (1-3)
●
Switch the machine on by pressing the key .
WAIT is displayed on the display. When
READY appears on the display the machine has
reached the necessary operating temperature;
●
Remove the capsule holder
●
Fit the capsule head downwards in the capsule
holder. The capsule contains the right quantity
of coffee for one cup of espresso
(10).
●
Replace the capsule holder on the capsule
cage and tighten until the handle is facing
you or slightly offset towards the right
●
Place the preheated cup (see «preheating
cups») under the «coffee» outlet
●
Depending on the choice of cup, (large or
small), press or
(11).
LARGE or SMALL now appears on the
display and preparation of the espresso
begins. The machine is set in the factory for
0.5dl of coffee
1.0dl of coffee
●
The machine stops automatically when the
desired filling level is reached. READY
appears on the display.
●
Remove the full cup, remove the capsule hold-
er and the used capsule
(12)
To ensure that the quality of your next cup of
espresso is ideal, replace the empty capsule
holder on the capsule cage to retain the heat.