ELECTRIC IGNITION SYSTEM
The electric ignition system operates by heating a small electric heating element positioned in the bottom of the
burner. Oil entering the burner is drawn by capillary attraction into stainless steel gauze, and then heated to its
ignition temperature by the heating element. The coil is energised for only one minute during each ignition cycle,
by turning the ignition timer dial.
Lighting (with Electric Ignition System)
A. Turn the control knob to position .
B. Open the front door only slightly.
C. Wait for one minute and then turn the ignition timer dial all the way.
In case of power outage, light a small amount of fuel or use a commercial lighter.
D. Close the door after about 2-3 minutes (depending on the draft)
E. Do not move beyond position until the flame has properly stabilized and is dominantly blue.
Note: Never relight the unit if the burner is still hot.
To Next Page
Loading...
