Page 14
Single account management
For single account management:
1. In the box for Port #1 in the Account column, enter a Net2Phone account
number.
2. In the PIN field, enter the Personal Identification Number for that account.
3. Check the Use account for all ports checkbox.
4. If you wish to be able to receive incoming MAX-to-MAX calls (calls from
another Net2Phone device) on a port, select its Y radio button in the Login
column.
5. After the desired changes have been entered, click the Save button to save
them.
NOTES:
?? When multiple ports are sharing a single account, only one of the ports
sharing the account may have the Y selected.
?? Only one call at a time can be made using any given account number.
?? Whenever a selection in the Login column is modified, the MAX must be
restarted before the change will take effect.
Multiple account management
For multiple account management:
1. For each port that has a telephone attached, enter the account number and
PIN you intend to use with that telephone.
2. Make sure that Use account for all ports is not checked.
3. If you wish to be able to receive incoming calls on a port, select the Y radio
button in its Login column.
4. After the desired changes have been entered, click the Save button to save
them.
Reminder: whenever a button in the Login column is selected or cleared,
the MAX must be rebooted before the change will take effect.
Restarting the System
To restart (or “reboot”) your Net2Phone MAX 420 system, click the Restart
System link to access the Restart System page, then select Click to restart
system.
NOTES:
?? The default values in the Network Configuration table do not require
change unless a firewall is in use.
?? The default values in the Voice Configuration table should normally
be left unchanged.
Net2Phone MAX 420 – Quick Start Guide Managing Single and Multiple Accounts
To Next Page
Loading...
Need help?
General
