• Detailed steps
Online step-by-step instructions with live links to additional content.
For MetroCluster configurations, see either:
• Install MetroCluster IP configuration
• Install MetroCluster Fabric-Attached configuration
Quick steps - AFF A700 and FAS9000
This guide gives graphic instructions for a typical installation of your system from racking
and cabling, through initial system bring-up. Use this guide if you are familiar with
installing NetApp systems.
Access the Installation and Setup Instructions PDF poster:
AFF A700 Installation and Setup Instructions
FAS9000 Installation and Setup Instructions
Video steps - AFF A700 and FAS9000
There are two videos; one showing how to rack and cable your system and one showing
an example of using the System Manager Guided Setup to perform initial system
configuration.
Video one of two: Hardware installation and cabling
The following video shows how to install and cable your new system.
Animation - Install and setup of an AFF A700 or FAS9000
Video two of two: Performing end-to-end software configuration
The following video shows end-to-end software configuration for systems running ONTAP 9.2 and later.
[] | https://img.youtube.com/vi/WAE0afWhj1c?/maxresdefault.jpg
Detailed guide - AFF A700 and FAS9000
This guide gives detailed step-by-step instructions for installing a typical NetApp system.
Use this guide if you want more detailed installation instructions.
Step 1: Prepare for installation
To install your system, you need to create an account on the NetApp Support Site, register your system, and
get license keys. You also need to inventory the appropriate number and type of cables for your system and
collect specific network information.
Before you begin
You need to have access to the Hardware Universe for information about site requirements as well as
432
To Next Page
Loading...
Need help?
General
