Locking button
4. Repeat the preceding steps for any remaining power supplies.
Step 2: Remove the fans
You must remove the six fan modules, located on in the front of the chassis, when replacing the chassis.
1. If you are not already grounded, properly ground yourself.
2. Remove the bezel (if necessary) with two hands, by grasping the openings on each side of the bezel, and
then pulling it toward you until the bezel releases from the ball studs on the chassis frame.
3. Press the terra cotta locking button on the fan module and pull the fan module straight out of the chassis,
making sure that you support it with your free hand.
The fan modules are short. Always support the bottom of the fan module with your free hand
so that it does not suddenly drop free from the chassis and injure you.
Animation - Remove/install fan
729
To Next Page
