Option 1: Using Onboard Key Manager
Steps
1. Boot the node to the boot menu.
2.
Select option 10,
Set onboard key management recovery secrets.
3. Enter the passphrase for the onboard key manager you obtained from the customer.
4.
At the prompt, paste the backup key data from the output of
security key-manager backup
show
OR security key-manager onboard show-backup command.
Example of backup data:
--------------------------BEGIN BACKUP--------------------------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.
.
.
.
H4nPQM0nrDRYRa9SCv8AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
AAAAAAAA
---------------------------END BACKUP---------------------------
The controller returns to the boot menu.
5.
Select option 1,
Normal Boot
6.
Give back only the CFO aggregates with the
storage failover giveback -fromnode local
-only-cfo-aggregates true
command.
◦ If the command fails because of a failed disk, physically disengage the failed disk, but leave the
disk in the slot until a replacement is received.
◦ If the command fails because of an open CIFS session, check with the customer how to close out
CIFS sessions.
Terminating CIFS can cause loss of data.
◦ If the command fails because the partner "not ready", wait 5 minutes for the NVRAMs to
synchronize.
◦ If the command fails because of an NDMP, SnapMirror, or SnapVault process, disable the
process. See the appropriate content for more information.
793
To Next Page
Loading...
