Step Perform on each controller module
Cable the e0M ports to the management network switches with the RJ45 cables:
DO NOT plug in the power cords at this point.
2. To complete setting up your system, see
Step 4: Complete system setup and configuration.
Option 3: Cable a two node switchless cluster, Ethernet configuration
RJ45 ports and management ports on the controller modules are connected to switches. The cluster
interconnect ports are cabled on both controller modules.
Before you begin
Contact your network administrator for information about connecting the system to the switches.
Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.
As you insert the connector, you should feel it click into place; if you do not feel it click, remove
it, turn it around and try again.
Steps
1. Use the illustration or the step-by-step instructions to complete the cabling between the controllers and to
the switches:
8
To Next Page
Loading...
