Need help?Do you have a question about the NetApp AFF A250 and is the answer not in the manual?
General| Form Factor | 2U |
|---|---|
| Drive Types | SSD |
| Operating System | ONTAP |
| Flash Type | NVMe |
| Redundancy | Yes |
| Controller | Dual |
| Connectivity | 10GbE, 25GbE, 100GbE |
| Protocols | NFS, CIFS, iSCSI, FC |
| Processor | Intel Xeon |
| Memory | 128 GB |
| Drive Options | 15.3TB SSDs |
| RAID Support | RAID-DP, RAID-TEC |
| Data Reduction | Inline deduplication, compression, compaction |
| Power Supply | Dual |
Provides comprehensive instructions for installing AFF A250 systems, covering various formats and steps.
Details requirements for system installation, including account creation, inventory, and network information.
Instructions for installing the system in a 4-post rack or NetApp system cabinet, including rail kits.
Explains required and optional cabling for platform's cluster using switchless or interconnect methods.
Guides system setup and configuration using cluster discovery via switch/laptop or direct controller connection.
Procedures for replacing the boot media and checking related encryption configurations.
Covers procedures for shutting down or taking over an impaired node for most systems and MetroCluster.
Comprehensive guide to replacing a controller module, including component transfers and reinstallation.
Instructions for safely removing the controller module from the system chassis.
Instructions for locating and replacing the boot media within the controller module.
Procedure to transfer the ONTAP boot image from a USB flash drive to the new boot media.
Procedure to install the replacement controller module into the chassis and boot it to Maintenance mode.
Procedure to replace the real-time clock (RTC) battery in the controller module.
To Next Page
