Need help?Do you have a question about the NetApp AFF A200 and is the answer not in the manual?
General| Model | AFF A200 |
|---|---|
| Category | Storage |
| Form Factor | 2U |
| Controller | Dual Controller |
| Maximum Drives | 24 |
| Drive Type | SSD |
| NVMe Support | Yes |
| Operating System | ONTAP |
| Storage Type | All-Flash |
| Supported Protocols | NFS, iSCSI, FC |
| Data Protection | SnapMirror, SnapVault |
| Management Interface | OnCommand System Manager, REST API |
| Connectivity | 10 GbE, 25 GbE, 32 Gb FC |
| Data Reduction | Compression, Deduplication |
| Power Supply | Dual Redundant Power Supply |
Guides for installing and setting up new storage systems using various content formats.
Procedures for system maintenance, including boot media replacement.
Detailed steps to check NVE/NSE configuration on older ONTAP versions.
Detailed steps to check NVE/NSE configuration on newer ONTAP versions.
Instructions for physically removing the controller module from the chassis.
Steps to remove and replace the boot media in the controller module.
Process for transferring the ONTAP image to the new boot media via USB.
Steps to restore NVE/NSE when using Onboard Key Manager.
Steps to restore NSE/NVE on older ONTAP versions.
Steps to restore NSE/NVE on newer ONTAP versions.
Overview of replacing the system chassis, moving components to the new chassis.
Procedure to shut down controllers before moving the chassis.
Instructions for moving power supplies from the old to the new chassis.
Steps to remove controller modules from the old chassis.
Instructions for moving drives from the old to the new chassis.
Procedure for removing the old chassis and installing the new one in the rack.
Steps to install controller modules in the new chassis.
Verifying and setting the system time on the replacement controller.
Verifying and setting the High Availability (HA) state of the controller module.
Running system-level diagnostics after component replacement.
Verifying system ID changes in an HA configuration after controller replacement.
Manually reassigning system IDs for disks in a stand-alone configuration.
Steps to shut down the controller before replacing a DIMM.
Procedure for removing the controller module to access components.
Instructions for replacing DIMMs within the controller module.
Procedure to shut down the controller before replacing the NVMEM battery.
Steps for removing the controller module to access the NVMEM battery.
Instructions for replacing the NVMEM battery in the controller module.
Procedure to shut down the controller before replacing the RTC battery.
Steps for removing the controller module to access the RTC battery.
Instructions for replacing the RTC battery in the controller module.
To Next Page
