AFF A200 System Documentation
Install and setup
Cluster configuration worksheet - AFF A200
You can use the
Cluster Configuration Worksheet to gather and record your site-specific IP addresses and
other information required when configuring an ONTAP cluster.
Start here: Choose your installation and setup experience
You can choose from different content formats to guide you through installing and setting
up your new storage system.
•
Quick steps
A printable PDF of step-by-step instructions with live links to additional content.
•
Video steps
Video step-by-step instructions.
Installation and setup PDF poster - AFF A200
You can use the
AFF A200 Installation and Setup Instructions poster to install and set up your new system.
The PDF poster provides step-by-step instructions with live links to additional content.
Installation and setup video - AFF A200
The
AFF A200 Setup Video shows end-to-end software configuration for systems running ONTAP 9.2.
Maintain
Boot media
Overview of boot media replacement - AFF A200
The boot media stores a primary and secondary set of system (boot image) files that the
system uses when it boots. Depending on your network configuration, you can perform
either a nondisruptive or disruptive replacement.
What you’ll need
You must have a USB flash drive, formatted to FAT32, with the appropriate amount of storage to hold the
image_xxx.tgz file.
Before you begin
• The nondisruptive and disruptive methods for replacing a boot media both require you to restore the var file
system:
1
To Next Page
Loading...
Need help?
General
