NetApp AFF - Page 377

Install and setup
Cluster configuration worksheet - AFF A300
You can use the worksheet to gather and record your site-specific IP addresses and other information required
when configuring an ONTAP cluster.
Cluster Configuration Worksheet
Start here: Choose your installation and setup experience
For most configurations, you can choose from different content formats.
•
Quick steps
A printable PDF of step-by-step instructions with live links to additional content.
•
Video steps
Video step-by-step instructions.
For MetroCluster configurations, see either:
•
Install MetroCluster IP configuration
• Install MetroCluster Fabric-Attached configuration
Installation and setup PDF poster - AFF A300
You can use the PDF poster to install and set up your new system. The PDF poster provides step-by-step
instructions with live links to additional content.
AFF A300 Installation and Setup Instructions
Installation and setup video - AFF A300
The following video shows end-to-end software configuration for systems running ONTAP 9.2.
AFF A300 Setup Video
Maintain
Boot media
Overview of boot media replacement - AFF A300
The boot media stores a primary and secondary set of system (boot image) files that the
system uses when it boots. Depending on your network configuration, you can perform
either a nondisruptive or disruptive replacement.
You must have a USB flash drive, formatted to FAT32, with the appropriate amount of storage to hold the
image_xxx.tgz file.
You also must copy the image_xxx.tgz file to the USB flash drive for later use in this procedure.
375