Air duct
Riser 2 (middle PCIe module)
Boot media screw
Boot media
3. Locate the failed boot media by the lit LED on the controller module motherboard.
4. Remove the boot media from the controller module:
a. Using a #1 Phillips head screwdriver, remove the screw holding down the boot media and set the screw
aside in a safe place.
b. Grasping the sides of the boot media, gently rotate the boot media up, and then pull the boot media
straight out of the socket and set it aside.
5. Align the edges of the replacement boot media with the boot media socket, and then gently push it into the
socket.
6. Check the boot media to make sure that it is seated squarely and completely in the socket.
If necessary, remove the boot media and reseat it into the socket.
7. Rotate the boot media down until it is flush with the motherboard.
8. Secure the boot media in place by using the screw.
848
To Next Page
Loading...
