NetApp AFF - Page 931

AFF A800 System Documentation
Install and setup
Start here: Choose your installation and setup experience
For most configurations (including ASA configurations), you can choose from different
content formats.
•
Quick steps
A printable PDF of step-by-step instructions with live links to additional content.
•
Video steps
Video step-by-step instructions.
•
Detailed steps
Online step-by-step instructions with live links to additional content.
If your system is in a MetroCluster IP configuration, see the
Install MetroCluster IP Configuration instructions.
Quick steps - AFF A800
This guide gives graphic instructions for a typical installation of your system from racking
and cabling, through initial system bring-up. Use the
AFF A800 Systems Installation and
Setup Instructions
if you are familiar with installing NetApp systems.
Videos - AFF A800
There are two videos - one showing how to rack and cable your system and one showing
an example of using the System Manager Guided Setup to perform initial system
configuration.
Video one of two: Hardware installation and cabling
The following video shows how to install and cable your new system.
Installation and Setup of an AFF A800
Video two of two: Perform end-to-end software configuration
The following video shows end-to-end software configuration for systems running ONTAP 9.2 and later.
NetApp video: Software configuration for vSphere NAS datastores for FAS/AFF systems running ONTAP 9.2
Detailed steps - AFF A800
This section gives detailed step-by-step instructions for installing an AFF A800 system.
929