What to do if I cannot access NetComm NF4V from WLAN?
If you cannot access your NetComm Wireless Router from the WLAN, check the Wi-Fi LED on the front of the unit to verify that the WLAN is enabled. If you're using a static IP address for the WLAN connection, ensure that the IP address and subnet mask of both the router and your computer(s) are on the same subnet. You can check the router's configuration from the Network Setup page.
How to fix web configuration that does not display properly on NetComm NF4V?
To fix a web configuration that isn't displaying correctly on your NetComm Wireless Router, delete the temporary web files and log in again. In Internet Explorer, go to Tools, Internet Options, and click the Delete Files button. In the Delete Files window, select Delete all offline content and click OK. (Steps may vary depending on your browser version.)
What to do if the Power LED does not light up on NetComm Wireless Router?
If the Power LED on your NetComm Wireless Router doesn't light up, ensure the power adapter is correctly connected to the device and plugged into a working power source, using only the adapter provided. Check that both the router and the power source are turned on and that the device is receiving sufficient power. Try turning the router off and on again. If the issue continues, it may indicate a hardware problem.
General| Model | NF4V |
|---|---|
| Device Type | Wireless Router |
| Wireless Frequency | 2.4GHz |
| Wireless Speed | 300Mbps |
| WAN Interface | Ethernet |
| LAN Interface | Ethernet |
| Ethernet Ports | 4 |
| WAN Ports | 1 |
| Firewall | SPI Firewall |
| Security | WPA, WPA2 |
| Antennas | 2 x External |
To Next Page
