NetCommWireless NF10WV Setup Guide

NetCommWireless NF10WV

6 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Wireless Setup Guide

NF10WV FAQs

Wireless Setup guide

Login to Web User Interface

1 Connect a computer and the NF10WV using an Ethernet cable. (A yellow Ethernet cable was provided with your

NF10WV).

2 Open a web browser (such as Google Chrome or Mozilla Firefox), type following address into the address bar and

press Enter.

http://192.168.20.1

3 Enter the following credentials in the User Name and Password fields:

User Name: admin

Password: admin

Login screen

Note – If no authentication prompt is displayed or you see a request time out message, refer to “What if I cannot access Web User

Interface guide” from FAQs section.

Other manuals for NetCommWireless NF10WV

User Guide84 pages

Questions and Answers:

B
Bradley StarkAug 2, 2025
How to fix NetCommWireless Network Router when the power LED does not light up?
- A
  Ashley WestAug 2, 2025
  If the Power LED on your NetCommWireless Network Router (NF10WV) doesn't light up, ensure the power adapter is correctly connected to both the device and a working power outlet, using only the adapter provided. Verify that both the router and the power source are turned on and supplying sufficient power. You can also try turning the router off and then on again. If the problem continues, it may indicate a hardware issue.
M
Matthew CoxAug 11, 2025
What to do if I cannot access web configuration pages on NetCommWireless Network Router?
- R
  Robin MartinezAug 11, 2025
  To access the web configuration pages of your NetCommWireless Network Router, first, ensure that remote administration access is enabled. If you've set up an inbound packet filter, confirm that your computer's IP address matches it. Also, your computer and the router's IP addresses must be on the same subnet for LAN access; you can check the subnet on the Network Setup page. If you've changed the router's IP address, use the new address in your web browser. If problems persist, reset the router to factory settings by holding the reset button for 7 seconds until the LEDs turn off, then navigate to 192.168.20.1 and log in with the username "admin" and password "admin".

NetCommWireless NF10WV Specifications

General

Brand	NetCommWireless
Model	NF10WV
Category	Gateway
Language	English

Related product manuals

Preview: NetCommWireless NF18ACV

NetCommWireless NF18ACV