Name: NetCommWireless NF10WV
Brand: NetCommWireless
Rating: 4 (1 reviews)

Questions and Answers:

Bradley StarkAug 2, 2025

How to fix NetCommWireless Network Router when the power LED does not light up?

A
Ashley WestAug 2, 2025
If the Power LED on your NetCommWireless Network Router (NF10WV) doesn't light up, ensure the power adapter is correctly connected to both the device and a working power outlet, using only the adapter provided. Verify that both the router and the power source are turned on and supplying sufficient power. You can also try turning the router off and then on again. If the problem continues, it may indicate a hardware issue.

Matthew CoxAug 11, 2025

What to do if I cannot access web configuration pages on NetCommWireless Network Router?

R
Robin MartinezAug 11, 2025
To access the web configuration pages of your NetCommWireless Network Router, first, ensure that remote administration access is enabled. If you've set up an inbound packet filter, confirm that your computer's IP address matches it. Also, your computer and the router's IP addresses must be on the same subnet for LAN access; you can check the subnet on the Network Setup page. If you've changed the router's IP address, use the new address in your web browser. If problems persist, reset the router to factory settings by holding the reset button for 7 seconds until the LEDs turn off, then navigate to 192.168.20.1 and log in with the username "admin" and password "admin".

Brand

Model

NF10WV

NetCommWireless NF10WV User Manual

Other manuals for NetCommWireless NF10WV