e) Enter the MAC address of the computer/device you are connecting to the router. The MAC address is a 12 character set
of numbers and letters (A-F), with every 2 characters separated by a colon.
f) Enter the IP address of the computer/device. This is the local address in the range of 192.168.20.x where x = a number
between 2 and 254.
g) Click the Apply/Save button.
h) Complete steps d) through g) for each device connected to the NF10WV router. Each entry will be listed in the Static IP
Lease List as shown below.
QoS Configuration Settings
a) Select Advanced Setup > Quality of Service
To Next Page
Loading...
