Low Priority QoS Queue Configuration
a) Select Advanced > Quality of Service > Queue Config.
b) Click the Add button.
c) Enter a name of 15 characters or less to reflect the device that will have low priority QoS e.g. PC2LowPriority.
d) Set the Enable option to Enable.
e) Set the Interface (Australian customers use atm0(0_8_35), NZ customers use atm0(0)0)100)).
f) Enter a Precedence. For the lowest priority, set it to 3. For the highest priority use 1.
g) Set the DSL Latency as Path0.
h) Click the Save/Apply button.
High Priority QoS Classification
a) Select Advanced > Quality of Service > QoS Classification.
To Next Page
Loading...
