Connect and Configure Other
Computers (Optional)
Now that you have one computer set up to access the Internet through the firewall, you can
connect other computers so they can share the modem.
1. Connect a Category 5 Ethernet patch cable between another computer and one of the
remaining numbered Local ports on the firewall.
2. Check to make sure that the associated port number’s Link light is lit. The light flashes
when data is being transferred over the connection.
Note: If the numbered Link light isn’t lit, go to Troubleshooting on page 13.
3. Go back to Installation Step 3 (pages 6 and 7) and go through the sequence of steps
applicable for each computer.
4. Restart each computer.
5. Test each computer’s connection by going to NETGEAR’s Web site
(www.NETGEAR.com) from each computer.
Note: If you have more than 8 computers or devices to connect to this firewall, you
must connect them to a hub or switch (such as the NETGEAR 8-port Fast Ethernet
Switch) and then connect the hub or switch to the firewall. By using hubs or
switches, you may connect up to 253 computers to the firewall.
11
5
5
To Next Page
Loading...
