Installation Guide
ASG1100 Lifestyle Gateway with ZigBee
Package Contents
Gateway
Ethernet cablePower adapter
Connect the Gateway
1. Verify the package contents.
2. Decide where to place the gateway.
Note: For best WiFi coverage, identify a relatively central location within the
premises. Ensure that the gateway can be conveniently wired to the broadband
router and is close to an AC outlet.
3. Install the gateway in the proper orientation:
• Mount vertically if most devices are on the same floor as the gateway.
• Place horizontally (after removing the stand) if the devices and gateway
occupy multiple floors.
4. Connect the cables:
a. Connect an Ethernet cable from one of the open ports of the broadband
router to the WAN Ethernet port of the gateway.
b. Pull wires gently to verify that gateway connections are secure.
c. Plug the power cord into the gateway and then plug the power adapter into
an AC outlet.
5. Wait until the Power and Devices LEDs on the gateway become solid green
(this could take a few minutes).
6. To begin the installation process, visit http://www.example.com and use
installer credentials to log in to the Example system.
Horizontal mount
Vertical mount
Broadband routerGateway
To Next Page
Need help?
General
