NETGEAR N300 EX2700 - Meet Your Extender

Get to Know Your Extender
5
N300 WiFi Range Extender
Meet Your Extender
LEDs are located on the front panel. Buttons are located on the side panel. The Factory
Reset button and an Ethernet port are located on the bottom.
Device
Router
Power LED
WPS LED
Link
LED
Link
LED
Power On/Off
Factory Reset
button
Ethernet port
button
WPS button
Figure 1. Extender front panel
Table 1. LEDs
LED Description
Router Link LED
The connection between the extender and the router or access point:
• Solid green. Best connection.
• Solid amber. Good connection.
• Solid red. Poor connection.
• Off. No connection.
Device Link LED
The connection between the extender and a computer or mobile device.
• Solid green. Best connection.
• Solid amber. Good connection.
• Solid red. Poor connection.
• Off. No connection.
Power LED
• Solid amber. The extender is booting.
• Solid green. The
extender is powered on.
• Off. The
extender is powered off.
WPS LED
• Solid green. WiFi security is enabled (WPA or WPA2).
• Blinking green. A
WPS connection is being established.
• Off. WiFi security is not enabled.