NETGEAR N300 - Page 3

Let’s get
started.
Connect the 12vDC power supply into
your router and into a power socket
Plug the short end of
the DSL splitter into
the telephone jack.
Take the dark grey cable and plug the
one end into red socket marked DSL on
the DSL splitter and the other end into
the power supply port marked IN
Take the light grey cable and plug the
one end into the power supply port
marked OUT and the other end into the
back of the router.
Your telephone now plugs
into the green socket marked
Phone of the DSL splitter.
Plug the yellow LAN cable into the yellow
port on the back of the router, and the other
end into the LAN port on your computer.
Switch your router on by pressing the power
button at the back of the router.
1
2
3
4
5
7
6