Wait approximately 2 minutes
until your modem turns on.
If your modem has a battery backup,
first remove and reinsert the battery
before connecting your
modem to power.
Package Contents:
N300 Wireless Router
with External Antennas
Installation Guide
Power adapter
Ethernet cable
Step 1:
Unplug the power
to turn off your modem.
Step 2:
Connect one end of the blue
Ethernet cable to your modem,
and the other end to the Internet port
on your router.
Plug in, then turn on your modem.
Step 3:
Step 6:Step 4:
Connect the power adapter to the
router, then plug it into an outlet.
If none of the LEDs turn on, make sure
the router is connected to a working outlet.
Wait until the Wireless LED turns
solid green.
Step 5:
Use another Ethernet cable to establish
a wired connection as shown in this diagram.
Optionally, connect wirelessly by using the
preset wireless security settings
located on the bottom label.
Open a browser.
If the Web page does not display,
close and re-open the browser
and enter http://routerlogin.net
in the address bar, or check the
“Troubleshooting” section in
the User Guide.
Laptop or Desktop
Computer
N300 Wireless Router with External Antennas
Modem
or Cable
Internet
DSL
(not included)
Connect your computer
to the router.
N300 Wireless Router
WNR1500
with External Antennas
To Next Page
Need help?
General
