NETGEAR Nighthawk C7000 - Connect to Network & Access Router

12
is ready for sharing. By default, the USB drive is available to all
computers on your local area network (LAN).
2. Select Start > Run.
3. Enter \\readyshare in the dialog box.
4. Click the OK button.
¾ To access the USB drive from a Mac:
1. Insert your USB storage drive into the USB port on the
modem router.
If your USB drive uses a power supply, you must use it when
you connect the USB drive to the modem router.
When you connect the USB drive to the modem router USB
port, it might take up to two minutes before it is ready for
sharing. By default, the USB drive is available to all computers
on your local area network (LAN).
2. Select Go > Connect to Server.
3. Enter smb://readyshare as the server address.
4. Click the Connect button.