Netgear Nighthawk D7000
Please follow the steps below to set up your Netgear Nighthawk D7000.
1. Ensure your NBN Connection Box is turned on.
2. Plug an Ethernet cable from the UNI-D1 port on your NBN Connection Box into the red
Internet port on your Nighthawk modem.
If UNI-D1 doesn’t work, try each UNI-D port.
3. Plug in the power cable and turn your Nighthawk modem on using the
Power On-Off button.
4. You can connect devices such as PC desktops, laptops or gaming consoles by plugging
Ethernet cables from the device to any of the four yellow LAN ports, or you can connect
devices via WiFi.
To Next Page
