NETGEAR ProSAFE WC7600 Installation Guide

9
6. Select the time zone in which the wireless controller is used.
7. (Optional) Configure the NTP settings.
8. Click the Apply button.
9. Select Configuration > System > IP/VLAN.
10. Enter the IP settings for your network and the VLANs that you want
to assign to the wireless controller.
Note: For large deployments, NETGEAR recommends that
the wireless controller and access points are in separate
VLANs to ensure uninterrupted connectivity between the
wireless controller and the access points.
Note: Clear the Untagged VLAN check box only if the hubs
and switches in your network support the VLAN (802.1Q)
standard. Change the untagged VLAN value only if the hubs
and switches in your network support the VLAN (802.1Q)
standard.
11. Click the Apply button.
The connection to the wireless controller is terminated because
you have changed its IP address.
12. Reconfigure your computer with an IP address and subnet mask
that is in the same IP subnet as the wireless controller. Use the
new IP address of the wireless controller to log in again.

NETGEAR ProSAFE WC7600 Specifications

General

Brand	NETGEAR
Model	ProSAFE WC7600
Category	Controller
Language	English