NETGEAR R6080 - Chapter 1 Hardware Overview of the Router

2. Restart Your Modem and Plug In Your Router
ta ~
Unplug your modem, remove and replace the backup battery if it uses one, and
then plug
the modem back in. Use the Ethernet cable to connect the modem to
the blue Internet port on the router.
Note:
If your Internet connection does not require a modem, connect your main
Ethernet cable
to the blue Internet port on the router.
Connect
the router to a power source. The router's Power LED(!) lights green
when
the router is ready.
3. Connect to the Internet
~
Make sure that the router's WiFi LED (<•>) is lit . Look on the router label for the
preassigned WiFi network name (SSID) and network key (password).
Open
the WiFi connection manager on your computer or other WiFi-enabled
device, find
the router's WiFi network name, and use the router's password to
connect.
Launch a web browser.
If the NETGEAR installation assistant does not display, visit
www.routerlogin.net. If a login window displays, enter admin for the user name
and
password for the password. Follow the onscreen instructions.
The router's Internet
LED lights ~green when the router is connected to the
Internet.