Need help?Do you have a question about the NETGEAR VMB3500 and is the answer not in the manual?
General| Model | VMB3500 |
|---|---|
| Category | Security Camera |
| Camera Type | Indoor/Outdoor |
| Field of View | 130 degrees |
| Night Vision | Yes |
| Connectivity | Wi-Fi |
| Audio | Two-way audio |
| Motion Detection | Yes |
| Power Source | AC power |
| Storage | Cloud storage |
| Weather Resistance | IP65 |
| Video Resolution | 1080p |
Connect the base station to your router using the included Ethernet cable for internet connectivity.
Connect the AC adapter to the base station and plug it into a power outlet.
Create a new Arlo account by launching the app and following the onscreen instructions.
Add a camera to an existing Arlo account by logging in and selecting 'Add Device'.
Bring the camera within 1 to 3 feet (30-100 cm) of the base station for syncing.
Press and hold the Sync button on the back of the base station for two seconds.
Wait for the Sync Status LED on the base station to blink green.
Press and hold the Sync button on the top of the camera for two seconds.
Repeat the syncing process for each additional camera to connect them.
Place your camera on a shelf or flat surface, or mount it to a wall.
Fasten mounting screw, hang magnetic mount, or use double-sided tape for wall mounting.
Explains the Power LED status (Green, Blinking Green, Amber, Off).
Explains the Internet LED status (Green, Blinking Green, Amber, Off).
Explains the Camera LED status (Green, Blinking Green, Blinking Amber, Amber, Off).
To Next Page
